Users should have the radio and interface powered prior to starting the program so this can occur. These are sent to the radio when the program starts. Consult the manual from your radio and also read below.Some radios require initialization commands for configuration.

When the radio control gives a warning 10 seconds after you start the logger, then you never had radio control at all, and you should check your hardware, and serial port settings.

To restart the radio radio interface polling select in the right-click menu from the bandmap “Reset radios”.

A warning message will be displayed when no response received from the radio and the radio will be changed to a manual radio by the program.

If the radio needs to be power cycled after the program has initialized, right click in the Bandmap and select Reset Radio to perform this initialization again.

Some radios require initialization commands for configuration.

Users generally increase this value to 13 – 15 seconds.

All radios: Timeout for all radios is default set to 10 seconds (user settable).

All radios: Band change is not allowed while transmitting.

When using a home-brew self-powered interface set the handshaking to:.

Please advise us of any corrections or needed changes. Note: Known settings for specific transceivers, as well as program features that they do not support are mentioned below as far as we know them.

FT-1000 series, FT-990 and FT-920 Setting filters.

N1MM logger loses communication with the radio (TS-850, TS-950 etc.).

General Icom Information (all Icom owners please read).

SDR-1000 and SDR-5000A (using Kenwood settings).

Setup DX, DXpedition, and General Purpose Contests.

Windows – Table of Contents View (long).

Call History and Reverse Call History Lookup.

Archive Files (1/2021) – N1MM on WindowsXP.

Ham radio deluxe supported radios